Moldova standards PDF

Hollow taper interface with flange contact surface - Part 4- Receivers of types T and U for hollow taper shanks of types T, TA and U. Original standard ISO 12164-4-2023 in PDF full version. Additional info + preview on request

Document status: Active

Hollow taper interface with flange contact surface - Part 5- Shanks of types AS, CS and ES. Original standard ISO 12164-5-2023 in PDF full version. Additional info + preview on request

Document status: Active

Hollow taper interface with flange contact surface - Part 6- Receivers of types AS, CS and ES for hollow taper shanks of types AS, CS and ES. Original standard ISO 12164-6-2023 in PDF full version. Additional info + preview on request

Document status: Active

Tools for moulding - Components of compression and injection moulds and diecasting dies - Terms and symbols. Original standard ISO 12165-2000 in PDF full version. Additional info + preview on request

Document status: Replaced by St ISO 12165-2019

Plain bearings - Hydrostatic plain journal bearings with drainage grooves under steady-state conditions - Part 1- Calculation of oil-lubricated plain journal bearings with drainage grooves. Original standard ISO 12167-1-2016 in PDF full version. Additional info + preview on request

Document status: Replaced by St ISO 12167-1-2023

Plain bearings - Hydrostatic plain journal bearings without drainage grooves under steady-state conditions - Part 1- Calculation of oil-lubricated plain journal bearings without drainage grooves. Original standard ISO 12168-1-2001 in PDF full version. Additional info + preview on request

Document status: Replaced by St ISO 12168-1-2019